Heat Shrinkable Sleeve Tape For Oil-gas Pipeline

Product Detail

Heat shrinkable sleeve for oil-gas pipeline

Heat shrinkable sleeve , which is developed and manufactured by Qingdao Huashida machinery Co., Ltd for anti-corrosion of pipeline. The hot melt adhesive is squeezed into the joint by the shrink power to form a perfectly sealed surface, after being heated. HSSC-1 is compatible with standard pipe coating, also can be used for coating bare, replacement pipe section and large redius.






Why does the Heat shrinkable sleeve of "Huashida" have the better adhesion for anti-corrision pipe (3PE)? First let us introduce for you the Construction of anti-corrision pipe (3PE).

layer system (3PE):

- First layer: Liquid epoxy.

- Second layer: Heat melt adhesive.

- Third layer: Radiation cross-linked, high density polyethylene film.









This system is a wrap-around heat shrinkable sleeve which replicates the structure and performance of mill-applied three-layer PE coatings.

During installation, the epoxy is applied to the prepared pipe surface and the heat shrinkable sleeve is immediately wrap around the joint over the wet epoxy. Heat is then applied to the sleeve which shrinks to form a tight fit around the joint. While curing, the epoxy forms strong mechanical and chemical bonds to the pipe surface & to the copolymer adhesive layer. The radiation cross linked outer layer forms a tough barrier against mechanical damage and moisture transmission.











Reamark: The thickness mainly according to the buyer’s requirements.




	ITEM	Standard	UNIT	Data
Adhesive	softening point	ASTM E 28	°C	70-80
	shear strength	DIN 30 672	N/cm	=100
Basic	specific density	ASTM D792	r/cm3	0.935-0.96
	tensile strength	ASTM D638	Mpa	15-20
	Elongation at break	ASTM D792	%	350
	hardness	ASTM D2240	ball	48
Heat Shrinkable Sleeve	peel strength	ASTM D1000	N/cm	>150
	water-intake rate	ASTM D570	%	0.05




Qingdao Huashida, the industry leader in corrosion protection and sealing inCHINA. Welcome to ask us more information.